Dlp- A83 Provision Orderwire - Cisco ONS 15454 Series Procedure Manual

DLP-A83 Provision Orderwire
•
•
•
Note
Under "Select applicable nodes," deselect any nodes where you do not want to add the user (all network
Step 5
nodes are selected by default).
Click OK.
Step 6
In the User Creation Results dialog box, verify that the user was added to all the nodes chosen in
Step 7
If not, click OK and repeat Steps
with the next step.
Return to your originating procedure (NTP).
Step 8
DLP-A83 Provision Orderwire
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the network view, click the Provisioning > Overhead Circuits tabs.
Step 1
Click Create.
Step 2
Step 3 In the Overhead Circuit Creation dialog box, complete the following fields in the Circuit Attributes area:
•
Cisco ONS 15454 Procedure Guide, R5.0
17-84
Password—Type the user password. The password must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) and special (+, #, %) characters, where at least two characters are
nonalphabetic and at least one character is a special character. For TL1 compatibility, the password
must be 6 to 10 characters. The password must not contain the user name.
Confirm Password—Type the password again to confirm it.
Security Level—Choose a security level for the user: RETRIEVE, MAINTENANCE,
PROVISIONING, or SUPERUSER. Refer to the "Security and Timing" chapter in the
Cisco ONS 15454 Reference Manual for information about the capabilities provided with each level.
Each security level has a different idle time. The idle time is the length of time that CTC can
remain idle before it locks up and the password must be reentered. The defaults are: Retrieve
user = unlimited, Maintenance user = 60 minutes, Provisioning user = 30 minutes, and Superuser
= 15 minutes. To change the idle times, refer to the
Security" procedure on page
This task provisions orderwire on the AIC or the AIC-I card.
An AIC or AIC-I card must be installed in Slot 9.
OC-N cards must be installed.
NTP-A24 Verify Card Installation, page 4-2
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces).
10-6.
2 through 6. If the user was added to all nodes, click OK and continue
Chapter 17
"NTP-A205 Modify Users and Change
DLPs A1 to A99
Step 5.
March 2005