Ntp- A246 Install Ethernet Cards And Connectors - Cisco ONS 15454 Series Procedure Manual

NTP-A246 Install Ethernet Cards and Connectors
•
•
•
If the card does not boot up properly, or the LED activity does not mimic
Step 6
•
•
•
Continue with the
Step 7
necessary.
Stop. You have completed this procedure.
NTP-A246 Install Ethernet Cards and Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning
Warning Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100
mm could pose an eye hazard. Statement 1056
Use of controls, adjustments, or performing procedures other than those specified may result in
Warning
hazardous radiation exposure. Statement 1057
Cisco ONS 15454 Procedure Guide, R5.0
2-10
The red FAIL LED blinks for 30 to 40 seconds.
All LEDs blink once and turn off for 1 to 5 seconds.
The ACT or ACT/STBY LED turns on. The SF LED can persist until all card ports connect to their
far end counterparts and a signal is present.
If the red FAIL LED does not turn on, check the power.
If you insert a card into a slot provisioned for a different card, all LEDs turn off.
If the red FAIL LED is on continuously or the LEDs behave erratically, the card is not installed
properly. Remove the card and repeat Steps
"NTP-A246 Install Ethernet Cards and Connectors" procedure on page 2-10
This procedure describes how to install the Ethernet cards (E100T-12,
E100T-G, E1000-2, E1000-2-G, G1000-4, G1K-4, ML100-T-12,
ML10002, and CE-100T-8).
Ethernet cards
NTP-A15 Install the Common Control Cards, page 2-2
As needed
Onsite
None
Chapter 2 Install Cards and Fiber-Optic Cable
Step
2 to 5.
5, check the following:
if
May 2006