Table 20-7 Sonet Threshold Options For The Ds3Xm-12 Card; Dlp- A388 Change Line And Threshold Settings For The Ds3/Ec1-48 Cards - Cisco ONS 15454 Series Procedure Manual

DLP-A388 Change Line and Threshold Settings for the DS3/EC1-48 Cards
Table 20-7
Parameter
CV
ES
FC
SES
UAS
Note
Return to your originating procedure (NTP).
Step 7
DLP-A388 Change Line and Threshold Settings for the DS3/EC1-48 Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note EC-1 functionality is not supported in Software Release 5.0.
Double-click the DS3/EC1-48 card where you want to change the line or threshold settings.
Step 1
Click the Provisioning tab.
Step 2
Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
Step 3
or SONET Thresholds tab.
Note
Cisco ONS 15454 Procedure Guide, R5.0
20-80
SONET Threshold Options for the DS3XM-12 Card
Description
Coding violations
Errored seconds
Failure count
Severely errored seconds
Unavailable seconds
The threshold value appears after the circuit is created.
This task changes the line and threshold settings for the DS3/EC1-48 cards.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
See Chapter 7, "Manage Alarms"
Options
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and click
Show Thresholds (STS and VT Term).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and click
Show Thresholds (STS and VT Term).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and click
Show Thresholds (STS and VT Term).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and click
Show Thresholds (STS and VT Term).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and click
Show Thresholds (STS and VT Term).
for information about the Alarm Profiles tab.
Chapter 20 DLPs A300 to A399
March 2005