Figure 6-4 Setting Circuit Attributes For A Ds-3 Circuit - Cisco ONS 15454 Series Procedure Manual

NTP-A184 Create an Automatically Routed DS-3 Circuit
Figure 6-4
If the circuit will be routed on a path protection, complete the
Step 8
Selectors" task on page
Click Next.
Step 9
Complete the
Step 10
In the Circuit Routing Preferences area
Step 11
available; choose based on your preferences:
Using Required Nodes/Spans—Check this check box to specify nodes and spans to include or
•
exclude in the CTC-generated circuit route.
Including nodes and spans for a circuit ensures that those nodes and spans are in the working path
of the circuit (but not the protect path). Excluding nodes and spans ensures that the nodes and spans
are not in the working or protect path of the circuit.
Review Route Before Creation—Check this check box to review and edit the circuit route before the
•
circuit is created.
VT-DS3 Mapped Conversion—Check this check box to create a circuit using the portless
•
transmultiplexing interface of the DS3XM-12 card.
Cisco ONS 15454 Procedure Guide, R5.0
6-20
Setting Circuit Attributes for a DS-3 Circuit
19-12.
"DLP-A510 Provision a DS-3 Circuit Source and Destination" task on page
(Figure
Chapter 6
"DLP-A218 Provision Path Protection
6-5), choose Route Automatically. Three options are
Create Circuits and VT Tunnels
22-3.
August 2005