Cisco ONS 15454 Series Procedure Manual page 224

NTP-A191 Create an E-Series EtherSwitch Circuit (Multicard or Single-Card Mode)
•
•
In the Circuits window, verify that the new circuits appear in the circuits list.
Step 12
Complete the
Step 13
Circuits" procedure on page
Stop. You have completed this procedure.
NTP-A191 Create an E-Series EtherSwitch Circuit (Multicard or
Single-Card Mode)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
EtherSwitch circuit. If you are already logged in, continue with
If a high number of VLANs is already used by the network, complete the
Step 2
Available VLANs" task on page 17-99
create a VLAN during each circuit creation task.)
If enough VLANs are not available, complete the
Step 3
free space.
Verify that the circuit source and destination Ethernet cards are provisioned for the mode of the circuit
Step 4
you will create, either multicard or single-card. See the
Mode" task on page
Provision and enable the Ethernet ports. See
Step 5
page
Step 6 From the View menu, choose Go to Network View.
Click the Circuits tab, then click Create.
Step 7
Cisco ONS 15454 Procedure Guide, R5.0
6-56
If you entered more than 1 in the Number of Circuits field and selected Auto-ranged, CTC
automatically creates the number of circuits entered in Number of Circuits. If auto-ranging cannot
complete all the circuits, for example, because sequential ports are unavailable at the source or
destination, a dialog box appears. Set the new source or destination for the remaining circuits, then
click Finish to continue auto-ranging. After completing the circuits, the Circuits window appears.
If you entered more than 1 in the Number of Circuits field and did not choose Auto-ranged, the
Circuit Creation dialog box appears so you can create the remaining circuits. Repeat Steps
through 10 for each additional circuit. After completing the circuits, the Circuits window appears.
"NTP-A135 Test Electrical Circuits" procedure on page 6-36
6-51, as applicable. Skip this step if you built a test circuit.
This procedure creates a multicard or single-card EtherSwitch circuit. It
does not apply to E-Series cards in port-mapped mode. To create a
port-mapped mode circuit, see
Card in Port-Mapped Mode, page
E-Series Ethernet cards (E100T-12/E100T-G, E1000-2/E1000-2-G) must
be installed at each end of the Ethernet circuit.
NTP-A127 Verify Network Turn Up, page 6-4
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
19-29.
19-13.
NTP-A192 Create a Circuit for an E-Series
6-59.
at the node where you will create the
Step
to verify that sufficient VLAN capacity is available. (You will
"DLP-A335 Delete VLANs" task on page 20-23
"DLP-A246 Provision E-Series Ethernet Card
"DLP-A220 Provision E-Series Ethernet Ports" task on
Chapter 6 Create Circuits and VT Tunnels
or the "NTP-A62 Test OC-N
2.
"DLP-A99 Determine
August 2005
5
to