Step 4; Purpose; Tools/Equipment; Dlp- A152 Modify A 1:N Protection Group - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
•
•
Click Apply. Confirm that the changes appear; if not, repeat the task.

Step 4

Note
Return to your originating procedure (NTP).
Step 5
DLP-A152 Modify a 1:N Protection Group

Purpose

Tools/Equipment

Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Verify that the DS-1 and DS-3 cards are installed according to the 1:N specifications in the
Step 1
Create a 1:N Protection Group" task on page
In node view, click the Provisioning > Protection tabs.
Step 2
In the Protection Groups area, click the 1:N protection group you want to modify.
Step 3
In the Selected Group area, change any of the following, as needed:
Step 4
•
•
•
•
See the
March 2007
Revertive—Check this box if you want traffic to revert to the working card after failure conditions
stay corrected for the amount of time chosen from the Reversion time drop-down list. Uncheck if
you do not want traffic to revert.
Reversion time—If the Revertive check box is selected, choose the reversion time from the
Reversion time drop-down list. The range is 0.5 to 12.0 minutes. The default is 5.0 minutes. This is
the amount of time that will elapse before the traffic reverts to the working card. Traffic can revert
when conditions causing the switch are cleared.
To convert electrical protection groups, see the
Cards from 1:1 Protection to 1:N Protection" procedure on page
This task modifies a 1:N protection group for DS-1 and DS-3 cards.
None
DLP-A72 Create a 1:N Protection Group, page 17-80
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Name—Type the changes to the protection group name. The name can have up to 32 alphanumeric
characters.
Available Cards—If cards are available, they will appear here. Use the arrow buttons to move them
into the Working Cards column.
Working Cards—Use the arrow buttons to move cards out of the Working Cards column.
Reversion Time—Choose a reversion time from the drop-down list. The range is 0.5 to 12.0 minutes.
The default is 5.0 minutes. This is the amount of time that will elapse before the traffic reverts to the
working card. Traffic can revert when conditions causing the switch are cleared.
"DLP-A72 Create a 1:N Protection Group" task on page 17-80
DLP-A152 Modify a 1:N Protection Group
"NTP-A91 Upgrade DS-1 and DS-3 Protect
17-80.
for field descriptions.
Cisco ONS 15454 Procedure Guide, R5.0
11-4.
"DLP-A72
18-21