Cisco ONS 15454 Series Procedure Manual page 547

Chapter 18 DLPs A100 to A199
Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
Step 3
or SONET Thresholds tab.
Note
Modify any of the settings found under these subtabs. For definitions of the Line settings, see
Step 4
Table
Electrical Path Threshold settings, see
see Table
Click Apply.
Step 5
Repeat Steps
Step 6
Table 18-11
Table 18-11
Parameter
Port #
Port Name
SF BER
SD BER
Line Type
Detected
Line Type
Line
Coding
Line
Length
March 2007
DLP-A167 Change Line and Threshold Settings for the DS3-12E or DS3N-12E Cards
See Chapter 7, "Manage Alarms"
18-11. For definitions of the Line Threshold settings, see
18-14.
3 through 5 for each subtab that has parameters you want to provision.
describes the values on the Provisioning > Line tabs for the DS3E cards.
Line Options for the DS3-12E and DS3N-12E Cards
Description
(Display only.) Sets the port number.
Sets the port name.
Sets the signal fail bit error rate.
Sets the signal degrade bit error rate.
Defines the line framing type.
Displays the detected line type
(read-only).
Defines the DS3E transmission coding
type.
Defines the distance (in feet) from
backplane connection to the next
termination point.
for information about the Alarm Behavior tab.
Table
Table 18-13. For definitions of the SONET Threshold settings,
Options
1 to 12
User-defined, up to 32 alphanumeric/ special
characters. Blank by default.
See the
Port" task on page
1E-3
•
1E-4
•
1E-5
•
1E-5
•
1E-6
•
1E-7
•
1E-8
•
1E-9
•
M13
•
C Bit
•
Auto Provisioned
•
M13
•
C Bit
•
Unframed
•
Unknown
•
B3ZS
0 - 225 (default)
•
226 - 450
•
Cisco ONS 15454 Procedure Guide, R5.0
18-12. For definitions of the
"DLP-A314 Assign a Name to a
20-8.
18-37