Dlp- A221 Provision E-Series Ethernet Ports For Vlan Membership - Cisco ONS 15454 Series Procedure Manual

DLP-A221 Provision E-Series Ethernet Ports for VLAN Membership
For each Ethernet port, provision the following parameters:
Step 3
•
•
•
•
•
Click Apply.
Step 4
Step 5 Repeat Steps
repeat Steps
and ready to be configured for VLAN membership.
Return to your originating procedure (NTP).
Step 6
DLP-A221 Provision E-Series Ethernet Ports for VLAN Membership
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the E-Series card graphic to open the card.
Step 1
Click the Provisioning > Ether VLAN tabs.
Step 2
Cisco ONS 15454 Procedure Guide, R5.0
19-14
Port Name—If you want to label the port, type a port name.
Mode—Choose the appropriate mode for the Ethernet port:
Valid choices for the E100T-12/E100T-G card are Auto, 10 Half, 10 Full, 100 Half, or 100 Full.
–
Valid choices for the E1000-2/E1000-2-G card are 1000 Full or Auto.
–
Both 1000 Full mode and Auto mode set the E1000-2 port to the 1000 Mbps and Full duplex
Note
operating mode; however, flow control is disabled when 1000 Full is selected. Choosing
Auto mode enables the E1000-2 card to autonegotiate flow control. Flow control is a
mechanism that prevents network congestion by ensuring that transmitting devices do not
overwhelm receiving devices with data. The E1000-2 port handshakes with the connected
network device to determine if that device supports flow control.
Enabled—Check this check box to activate the corresponding Ethernet port.
Priority—Choose a queuing priority for the port. Options range from 0 (Low) to 7 (High). Priority
queuing (IEEE 802.1Q) reduces the impact of network congestion by mapping Ethernet traffic to
different priority levels. Refer to the priority queuing information in the Cisco ONS 15454 Reference
Manual. This parameter does not apply to an E-Series card in port-mapped mode.
Stp Enabled—Check this check box to enable the Spanning Tree Protocol (STP) on the port. This
parameter does not apply to an E-Series card in port-mapped mode. Refer to the spanning tree
information in the Ethernet Card Software Feature and Configuration Guide for the
Cisco ONS 15454 SDH, Cisco ONS 15454, and Cisco ONS 15327.
1 through 4 for all other cards in the VLAN, or if the E-Series card is in port-mapped mode,
1 through 4 for the other card in a point-to-point circuit. Your Ethernet ports are provisioned
This task provisions E-Series ports for VLAN membership. It does not
apply to E-Series cards in port-mapped mode.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Chapter 19 DLPs A200 to A299
September 2005