Dlp- A325 Provision A Vcat Circuit Route - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
DLP-A325 Provision a VCAT Circuit Route
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the Circuit Creation wizard in the Route Review and Edit area, choose the member number from the
Step 1
Route Member Number drop-down list.
Click the source node icon if it is not already selected.
Step 2
Starting with a span on the source node, click the arrow of the span you want the circuit to travel. The
Step 3
arrow turns white. In the Selected Span area, the From and To fields provide span information. The
source STS appears.
Figure 20-3
Click Add Span. The span is added to the Included Spans list and the span arrow turns blue.
Step 4
Repeat Steps
Step 5
intermediary nodes.
Repeat Steps
Step 6
March 2005
This task provisions the circuit route for manually routed VCAT circuits.
None
DLP-A60 Log into CTC, page 17-66
The Circuit Creation wizard Route Review and Edit page must be open.
As needed
Onsite or remote
Provisioning or higher
Figure 20-3 shows an example.
Manually Routing a VCAT Circuit
3 and 4 until the circuit is provisioned from the source to the destination node through all
1 through 5 for each member.
DLP-A325 Provision a VCAT Circuit Route
Cisco ONS 15454 Procedure Guide, R5.0
20-15