Dlp- A326 Change A Blsr Node Id - Cisco ONS 15454 Series Procedure Manual

DLP-A326 Change a BLSR Node ID
Return to your originating procedure (NTP).
Step 7
DLP-A326 Change a BLSR Node ID
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
On the network map, double-click the node with the node ID you want to change.
Step 2
Click the Provisioning > BLSR tabs.
Step 3
Choose a Node ID number. Do not choose a number already assigned to another node in the same BLSR.
Step 4
Click Apply.
Step 5
Step 6 Return to your originating procedure (NTP).
DLP-A327 Configure the CTC Alerts Dialog Box for Automatic Popup
Purpose
Tools
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the CTC Alerts toolbar icon.
Step 1
In the CTC Alerts dialog box, choose one of the following:
Step 2
•
•
•
Step 3 Click Close.
Cisco ONS 15454 Procedure Guide, R5.0
20-16
This task changes a BLSR node ID.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
This task sets up the CTC Alerts dialog box to open for all alerts, for circuit
deletion errors only, or never. The CTC Alerts dialog box displays network
disconnection, Send-PDIP inconsistency, circuit deletion status, condition
retrieval errors, and software download failure.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
All alerts—Sets the CTC Alerts dialog box to open automatically for all notifications.
Error alerts only—Sets the CTC Alerts dialog box to open automatically for circuit deletion errors
only.
Never—Sets the CTC Alerts dialog box to never open automatically.
Chapter 20 DLPs A300 to A399
March 2005