Dlp- A529 Delete Ethernet Rmon Alarm Thresholds - Cisco ONS 15454 Series Procedure Manual

DLP-A529 Delete Ethernet RMON Alarm Thresholds
Click Apply. The new network map appears.
Step 5
Click OK.
Step 6
If the ONS 15454 icons are not visible, right-click the network view and choose Zoom Out. Repeat until
Step 7
all the ONS 15454 icons are visible. (You can also choose Fit Graph to Window.)
If you need to reposition the node icons, drag and drop them one at a time to a new location on the map.
Step 8
If you want to change the magnification of the icons, right-click the network view and choose Zoom In.
Step 9
Repeat until the ONS 15454 icons are displayed at the magnification you want.
Return to your originating procedure (NTP).
Step 10
DLP-A529 Delete Ethernet RMON Alarm Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
Double-click the Ethernet card where you want to delete the RMON alarm thresholds.
Step 1
In card view, click the Provisioning > RMON Thresholds tabs.
Step 2
Note
Click the RMON alarm threshold you want to delete.
Step 3
Step 4 Click Delete. The Delete Threshold dialog box appears.
Step 5 Click Yes to delete the threshold.
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15454 Procedure Guide, R5.0
22-26
This task deletes remote monitoring (RMON) threshold crossing alarms
for Ethernet ports.
None
DLP-A533 Create Ethernet RMON Alarm Thresholds, page 22-28
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
The ONS 15454 ML-Series card uses the Cisco IOS CLI for managing RMON.
For the CE-Series cards, click the Provisioning > Ether Ports > RMON Thresholds tabs or
Provisioning > POS Ports > RMON Thresholds tabs.
Chapter 22 DLPs A500 to A599
October 2005