Dlp- A498 Switch Between Tdm And Dwdm Network Views - Cisco ONS 15454 Series Procedure Manual

Chapter 21 DLPs A400 to A499
Disconnect the network fiber cable from the GBIC SC connector or SFP LC duplex connector. If the SFP
Step 1
connector has a latch securing the fiber cable, pull it upward to release the cable.
If you are using a GBIC with clips:
Step 2
a.
b.
If you are using a GBIC with a handle:
Step 3
a.
b.
c.
Step 4 If you are using an SFP:
a.
b.
c.
d.
Return to your originating procedure (NTP).
Step 5
DLP-A498 Switch Between TDM and DWDM Network Views
Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
From the Network Scope drop-down list on the toolbar, choose one of the following:
Step 2
•
•
•
Note
March 2005
Release the GBIC from the slot by squeezing the two plastic tabs on each side of the GBIC.
Slide the GBIC out of the slot. A flap closes over the slot to protect the connector on the
Gigabit Ethernet card.
Release the GBIC by opening the handle.
Pull the handle of the GBIC.
Slide the GBIC out of the slot. A flap closes over the slot to protect the connector on the Gigabit
Ethernet card.
If the SFP connector has a latch securing the fiber cable, pull it upward to release the cable.
Pull the fiber cable straight out of the connector.
Unplug the SFP connector and fiber from the card.
Slide the SFP out of the slot.
Use this task to switch between time division multiplexing (TDM) and
DWDM network views.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
All—Displays both TDM and DWDM nodes.
TDM—Displays only ONS 15454s with SONET or SDH cards including the transponder (TXP) and
muxponder (MXP) cards.
DWDM—Displays only ONS 15454s with DWDM cards, including the transponder and muxponder
cards.
For information about DWDM, TXP, and MXP cards, refer to the Cisco ONS 15454 DWDM
Installation and Operations Guide.
DLP-A498 Switch Between TDM and DWDM Network Views
Cisco ONS 15454 Procedure Guide, R5.0
21-27