Cisco ONS 15454 Series Procedure Manual page 141

Chapter 5 Turn Up Network
NTP-A176 Four-Fiber BLSR Acceptance Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This procedure might be service affecting if performed on a node carrying traffic.
Caution
This procedure requires that you create test circuits and perform a ring switch. For clarity, "Node 1"
Note
refers to the login node where you begin the procedure. "Node 2" refers to the node connected to the east
OC-N trunk (span) card of Node 1, "Node 3" refers to the node connected to the east OC-N trunk card
of Node 2, and so on.
Complete the
Step 1
will be called Node 1.) If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Click the Alarms tab.
Step 3
a.
b.
c.
Click the Conditions tab.
Step 4
a.
b.
On the network map, double-click Node 1.
Step 5
Complete the
Step 6
Step 7 Complete the
Create a test circuit between Node 1 and Node 2.
Step 8
•
•
December 2004
This procedure tests a four-fiber BLSR.
Test set and cables appropriate to the test circuit you will create
NTP-A40 Provision BLSR Nodes, page 5-10
NTP-A126 Create a BLSR, page 5-12
As needed
Onsite
Provisioning and higher
"DLP-A60 Log into CTC" task on page 17-66
Verify that the alarm filter is not on. See the
page 19-17 as necessary.
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
Complete the "DLP-A516 Export CTC Data" task on page 22-6
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
Complete the "DLP-A516 Export CTC Data" task on page 22-6
information.
"DLP-A92 Four-Fiber BLSR Exercise Span Test" task on page
"DLP-A217 BLSR Exercise Ring Test" task on page
For DS-1 circuits, complete the
procedure on page 6-6. When you set the circuit state, choose IS and check the Apply to drop ports
check box.
For DS-3 circuits, complete the
procedure on page 6-18. When you set the circuit state, choose IS and check the Apply to drop
ports check box.
on the BLSR you are testing. (This node
"DLP-A227 Disable Alarm Filtering" task on
"NTP-A181 Create an Automatically Routed DS-1 Circuit"
"NTP-A184 Create an Automatically Routed DS-3 Circuit"
Cisco ONS 15454 Procedure Guide, R5.0
NTP-A176 Four-Fiber BLSR Acceptance Test
to export the alarm information.
to export the conditions
17-91.
19-10.
5-15