Chapter 18
DLPs A100 to A199
Repeat Steps
Step 6
Table 18-3
Table 18-3
Parameter
Port #
Port Name
SF BER
SD BER
Line Type
Line Coding
Line Length
Admin State
March 2007
DLP-A165 Change Line and Threshold Settings for the DS1-14 or DS1N-14 Cards
3
through
5
for each subtab that has parameters you want to provision.
describes the values on the Provisioning > Line tabs for the DS-1 cards.
Line Options for DS1-14 and DS1N-14 Cards
Description
(Display only.) Sets the port
number.
Sets the port name.
Sets the signal fail bit error
rate.
Sets the signal degrade bit
error rate.
Defines the line framing type.
Defines the DS-1
transmission coding type.
Defines the distance (in feet)
from the backplane
connection to the next
termination point.
Sets the port service state
unless network conditions
prevent the change.
Options
1 to 14
User-defined, up to 32 alphanumeric/special characters.
Blank by default.
See the
"DLP-A314 Assign a Name to a Port" task on
page
20-8.
1E-3
•
1E-4
•
1E-5
•
1E-5
•
1E-6
•
1E-7
•
1E-8
•
1E-9
•
D4
•
ESF - Extended Super Frame
•
Unframed
•
AMI - Alternate Mark Inversion (default)
•
B8ZS - Bipolar 8 Zero Substitution
•
0 - 131
•
132 - 262
•
263 - 393
•
394 - 524
•
525 - 655
•
IS—Puts the port in-service. The port service state
•
changes to IS-NR.
IS,AINS—Puts the port in automatic in-service.
•
The port service state changes to OOS-AU,AINS.
OOS,DSBLD—Removes the port from service and
•
disables it. The port service state changes to
OOS-MA,DSBLD.
OOS,MT—Removes the port from service for
•
maintenance. The port service state changes to
OOS-MA,MT.
Cisco ONS 15454 Procedure Guide, R5.0
18-29