Cisco ONS 15454 Series Procedure Manual page 321

Chapter 12 Upgrade Cards and Spans
Physically insert the new high-density electrical card into the protect slot. Be sure to remove the plastic
Step 9
protective covers on rear of the card before installing the card.
Open the ejectors on the card.
a.
Slide the card into the slot along the guide rails.
b.
Close the ejectors.
c.
Wait for the IMPROPRMVL alarm to clear and the card to become standby. For more information
about LED behavior during the high-density card boot-up, see the
Cards" procedure on page
Because the low-density working card is now active, switch traffic away from the low-density card:
Step 10
In node view, double-click the slot where the low-density card is installed.
a.
Click the Maintenance > Protection tabs.
b.
c. Double-click the protection group that contains the working card.
d. Click the low-density card slot.
e. Click Switch and Yes in the Confirmation dialog box.
Physically remove the low-density card you switched traffic away from in
Step 11
Open the card ejectors.
a.
Slide the card out of the slot. This raises the
b.
is complete.
Change the low-density card to the high-density card in CTC:
Step 12
Right-click the slot where you removed the low-density card and choose Change Card from the
a.
drop-down list.
Choose the new card type from the Change to drop-down list.
b.
Click OK.
c.
Insert the new high-density electrical card into the slot where you removed the low-density card. Be sure
Step 13
to remove the plastic protective covers on rear of the card before installing the card:
Open the ejectors on the card.
a.
Slide the card into the slot along the guide rails.
b.
c. Close the ejectors.
Wait for the IMPROPRMVL alarm to clear and the card to become standby. For more information
about LED behavior during high-density electrical card bootup, see the
Electrical Cards" procedure on page
Step 14 Clear the switch you performed in
a. In node view, double-click the slot where you installed the high-density card in
In the Maintenance > Protection tab, double-click the protection group that contains the reporting
b.
card.
Click the selected group.
c.
Click Clear and click Yes in the confirmation dialog box.
d.
The protect card in should now become standby.
January 2005
NTP-A308 Upgrade In-Service Low-Density Electrical Cards to High-Density Electrical Cards
2-8.
IMPROPRMVL
2-8.
Step 10:
"NTP-A17 Install the Electrical
Step 10:
alarm, which will clear when the upgrade
"NTP-A17 Install the
Step
Cisco ONS 15454 Procedure Guide, R5.0
13.
12-9