Dlp- A158 Change User Password And Security Level On A Single Node - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
In the Reference Lists area, you can change the following information:
Step 4
Note
•
•
•
Click Apply. Confirm that the changes appear; of not, repeat the task.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-A158 Change User Password and Security Level on a Single Node
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Security > Users tabs.
Step 1
Click the user whose settings you want to modify, then click Change.
Step 2
In the Change User dialog box, you can:
Step 3
•
•
•
See the
Click OK.
Step 4
Note
Return to your originating procedure (NTP).
Step 5
March 2007
Reference lists define up to three timing references for the node and up to six BITS Out
references. BITS Out references define the timing references used by equipment that can be
attached to the node's BITS Out pins on the backplane. If you attach equipment to BITS Out
pins, you normally attach it to a node with Line mode because equipment near the external
timing reference can be directly wired to the reference.
NE Reference
BITS 1 Out
BITS 2 Out
This task changes settings for an existing user at one node.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Superuser
Change a user password
Modify the user security level
Lock out the user
"NTP-A30 Create Users and Assign Security" procedure on page 4-4
User settings that you changed during this task will not appear until that user logs off and logs
back in.
DLP-A158 Change User Password and Security Level on a Single Node
Cisco ONS 15454 Procedure Guide, R5.0
for field descriptions.
18-25