Cisco ONS 15454 Series Procedure Manual page 821

Appendix A CTC Information and Shortcuts
Table A-3 CTC Menu and Toolbar Options (continued)
Menu Menu Option
Tools Circuits
Overhead Circuits
Tools Topology Upgrade
(cont.)
Manage VLANs
Open TL1
Connection
Open IOS
Connection
Help Contents and Index
User Manuals
About CTC
December 2004
Toolbar Description
— Displays the following options:
Repair Circuits—Repairs incomplete circuits following replacement of the
•
ONS 15454 alarm interface panel (AIP). Refer to the Cisco ONS 15454
Troubleshooting Guide for more information.
Reconfigure Circuits—Allows you to reconfigure circuits. See the
•
"NTP-A298 Reconfigure Circuits" procedure on page 9-9
information.
Set Path Selector Attributes—Allows you to edit path protection circuit path
•
selector attributes. See the
Selectors" task on page
Set Circuit State—Allows you to change a circuit state. See the
•
Change a Circuit Service State" task on page
Roll Circuit—Allows you to reroute live traffic without interrupting service.
•
This feature requires a Cisco ONS 15600 on your network. Refer to the
Cisco ONS 15600 Procedure Guide.
• Delete Rolls —This feature requires an ONS 15600 on your network. Refer
to the Cisco ONS 15600 Procedure Guide.
— Displays the Repair IP Tunnels option, which fixes circuits that are in the
INCOMPLETE state as a result of node IP address changes. See the
Repair an IP Tunnel" task on page
— Displays the following options:
Convert UPSR to BLSR—Converts a path protection to a bidirectional line
•
switch ring (BLSR). See the
Two-Fiber BLSR Automatically" procedure on page
Convert Unprotected to UPSR—Converts a point-to-point or linear
•
add/drop multiplexer (ADM) to path protection. See the
Convert a Point-to-Point or Linear ADM to a Path Protection
Automatically" procedure on page
— Displays a list of VLANs that have been created and allows you to delete
VLANS. See the
Displays the TL1 session dialog box so you can create a TL1 session to a
specific node. Refer to the Cisco ONS 15454 and Cisco ONS 15327 TL1
Command Guide.
Displays the Cisco IOS command line interface dialog box if a Cisco IOS
capable card (ML1000-2 or ML100T-12) is installed in the node. Refer to the
Refer to the Ethernet Card Software Feature and Configuration Guide.
— Displays the online help window.
— Displays the Cisco ONS 15454 documentation.
— Displays the software version and the nodes in the CTC session.
"DLP-A233 Edit Path Protection Circuit Path
19-22.
20-23.
"NTP-A267 Convert a Path Protection to a
13-11.
"DLP-A335 Delete VLANs" task on page
Cisco ONS 15454 Procedure Guide, R5.0
Manage the CTC Window
for more
"DLP-A230
19-19.
"DLP-A336
13-13.
"NTP-A299
20-23.
A-7