DLP-A257 View Ethernet Utilization PM Parameters
In node view, double-click the E-Series or G-Series Ethernet card where you want to view PM counts.
Step 1
The card view appears.
Click the Performance > Utilization tabs
Step 2
Figure 19-5
Card View
Performance
Utilization
Step 3
Click Refresh. Performance monitoring utilization values for each port on the card appear.
View the Port # column to find the port you want to monitor.
Step 4
The transmit (Tx) and receive (Rx) bandwidth utilization values for the previous time intervals appear
Step 5
in the Prev-n columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in
the Cisco ONS 15454 Troubleshooting Guide.
Note
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15454 Procedure Guide, R5.0
19-40
G-Series Utilization on the Card View Performance Window
tab
tab
Interval
menu
To refresh, reset, or clear PM counts, see the
on page
8-2.
(Figure
19-5).
Refresh
Help
button
button
"NTP-A253 Change the PM Display" procedure
Chapter 19
DLPs A200 to A299
September 2005