Figure - Cisco ONS 15454 Series Procedure Manual

NTP-A122 Monitor Electrical Performance

Figure 8-1

Card View
Performance
Directions
radio buttons
Intervals
radio buttons
Step 5 In the signal type drop-down lists, click one of the following options:
• DSn (card port)
VTn (VT path)
•
STSn (STS within the VT path)
•
Click Refresh.
Step 6
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 7
Curr (current) and Prev-n (previous) columns. For PM parameter definitions, refer to the "Performance
Monitoring" chapter in the Cisco ONS 15454 Troubleshooting Guide.
To refresh, reset, or clear PM counts, see the
page 8-2.
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
8-4
Viewing Electrical Card Performance Monitoring Information
tab
Signal-type port
drop-down list
Refresh Auto-refresh
button drop-down list
"NTP-A253 Change the PM Display" procedure on
Chapter 8 Monitor Performance
Baseline Clear Help
button button button
December 2004