Dlp- A264 Provision A J1 Path Trace On Circuit Source And Destination Ports - Cisco ONS 15454 Series Procedure Manual

DLP-A264 Provision a J1 Path Trace on Circuit Source and Destination Ports
Cisco recommends that you set the DRI port HOT value to zero and the circuit path selector HOT value
Note
to a number equal to or greater than zero.
From the View menu, choose Go to Network View.
Step 1
Click the Circuits tab.
Step 2
Click the path protection circuit you want to edit, then click Edit.
Step 3
Step 4 In the Edit Circuit window, click the UPSR Selectors tab.
Step 5 Create a hold-off time for the circuit source and destination ports:
a.
b.
Click Apply, then close the Edit Circuit window by choosing Close from the File menu.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-A264 Provision a J1 Path Trace on Circuit Source and Destination Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This task assumes you are setting up path trace on a bidirectional circuit and setting up transmit strings
Note
at the circuit source and destination.
From the View menu, choose Go to Network View.
Step 1
Click the Circuits tab.
Step 2
For the STS circuit you want to monitor, verify that the source and destination ports are on a card that
Step 3
can transmit and receive the path trace string. See
Cisco ONS 15454 Procedure Guide, R5.0
19-46
In the Holder Off Timer area, double-click the cell of the circuit source port (top row), then type the
new hold-off time. The range is 0 to 10,000 ms in increments of 100.
In the Hold-Off Timer area, double-click the cell of the circuit destination port (bottom row), then
type the hold-off time entered in Step
This task creates a path trace on STS circuit source ports and destination
ports or a VCAT circuit member.
ONS 15454 cards capable of transmitting and receiving path trace must be
installed at the circuit source and destination ports. See
page 19-47
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
a.
for a list of cards.
Table 19-3 for a list of cards.
Chapter 19 DLPs A200 to A299
Table 19-3 on
September 2005