Dlp- A65 Create A Static Route - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
Return to your originating procedure (NTP).
Step 10
DLP-A65 Create a Static Route
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Network tabs.
Step 1
Click the Static Routing tab. Click Create.
Step 2
Step 3 In the Create Static Route dialog box, enter the following:
•
•
•
•
Click OK. Verify that the static route appears in the Static Route window.
Step 4
Note
Return to your originating procedure (NTP).
Step 5
March 2005
This task creates a static route to establish CTC connectivity to a computer
on another network.
None
DLP-A60 Log into CTC, page 17-66
Required if either of the following conditions is true:
•
•
Onsite or remote
Provisioning or higher
Destination—Enter the IP address of the computer running CTC. To limit access to one computer,
enter the full IP address and a subnet mask of 255.255.255.255. To allow access to all computers on
the 192.168.1.0 subnet, enter 192.168.1.0 and a subnet mask of 255.255.255.0. You can enter a
destination of 0.0.0.0 to allow access to all CTC computers that connect to the router.
Mask—Enter a subnet mask. If the destination is a host route (that is, one CTC computer), enter a
32-bit subnet mask (255.255.255.255). If the destination is a subnet, adjust the subnet mask
accordingly, for example, 255.255.255.0. If the destination is 0.0.0.0, CTC automatically enters a
subnet mask of 0.0.0.0 to provide access to all CTC computers. You cannot change this value.
Next Hop—Enter the IP address of the router port or the node IP address if the CTC computer is
connected to the node directly.
Cost—Enter the number of hops between the ONS 15454 and the computer.
Static route networking examples are provided in the "CTC Network Connectivity" chapter of
the Cisco ONS 15454 Reference Manual.
CTC computers on one subnet need to connect to ONS 15454s that are
connected by a router to ONS 15454s residing on another subnet. Open
Shortest Path First (OSPF) is not enabled and the end network element
(ENE) gateway setting is not checked.
You need to enable multiple CTC sessions among ONS 15454s
residing on the same subnet and the ENE gateway setting is not
enabled.
DLP-A65 Create a Static Route
Cisco ONS 15454 Procedure Guide, R5.0
17-73