Dlp- A122 Enable/Disable Intermediate Path Performance Monitoring - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
DLP-A122 Enable/Disable Intermediate Path Performance Monitoring
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The monitored IPPM parameters are STS CV-P, STS ES-P, STS SES-P, STS UAS-P, and STS FC-P.
Note
Far-end path monitoring can be performed on the OC3-4 and EC1 cards. For PM parameter definitions,
refer to the "Performance Monitoring" chapter of the Cisco ONS 15454 Troubleshooting Guide.
An OC-48 IR card used in a bidirectional line switched ring (BLSR) does not support IPPM during a
Note
protection switch.
In node view, double-click the OC-N card you want to monitor. The card view appears.
Step 1
See
Click the Provisioning > SONET STS tabs
Step 2
March 2007
Table 18-1 on page 18-7 for a list of OC-N LTE cards.
DLP-A122 Enable/Disable Intermediate Path Performance Monitoring
This task enables or disables intermediate path performance monitoring
(IPPM), which allows you to monitor large amounts of STS traffic
through intermediate nodes.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
(Figure 18-5).
Cisco ONS 15454 Procedure Guide, R5.0
18-9