Dlp- A383 Delete A Firewall Tunnel - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
Click Delete.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-A383 Delete a Firewall Tunnel
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the Provisioning > Network > Firewall subtabs.
Step 1
Click the firewall tunnel that you want to delete.
Step 2
Click Delete.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-A384 Add a Member to a VCAT Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
March 2005
This task removes a firewall tunnel.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Superuser
This task adds a member to the following virtual concatenated (VCAT)
circuits:
Software Link Capacity Adjustment Scheme (SW-LCAS) VCAT
•
circuits on FC_MR-4 (enhanced mode) cards
Non-LCAS and LCAS circuits on CE-100T-8 cards
•
Adding a member to a VCAT circuit changes the size of the circuit. The
new members use the VCAT member source, destination, and routing
preference (common fiber or split routing) specified during the VCAT
circuit creation procedure.
FC_MR-4 card (enhanced mode) or CE-100T-8 card
DLP-A60 Log into CTC, page 17-66
VCAT circuits must exist on the network. See the
Automatically Routed VCAT Circuit" procedure on page 6-86
"NTP-A265 Create a Manually Routed VCAT Circuit" procedure on
page 6-90.
As needed
Onsite or remote
Provisioning or higher
DLP-A383 Delete a Firewall Tunnel
"NTP-A264 Create an
Cisco ONS 15454 Procedure Guide, R5.0
or the
20-65