Dlp- A210 Change Aic-I Card Orderwire Settings - Cisco ONS 15454 Series Procedure Manual

DLP-A210 Change AIC-I Card Orderwire Settings
DLP-A210 Change AIC-I Card Orderwire Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution When provisioning orderwire for ONS 15454s residing in a ring, do not provision a complete orderwire
loop. For example, a four-node ring typically has east and west ports provisioned at all four nodes.
However, to prevent orderwire loops, provision two orderwire ports (east and west) at all but one of the
ring nodes.
Before you begin, make a list of the ONS 15454 slots and ports that require orderwire communication.
Tip
In node view, double-click the AIC-I card to display it in card view.
Step 1
Click the Provisioning > Local Orderwire tabs or the Provisioning > Express Orderwire tabs,
Step 2
depending on the orderwire path that you want to create. Provisioning steps are the same for both types
of orderwire.
If needed, adjust the Tx and Rx dBm by moving the slider to the right or left for the headset type
Step 3
(four-wire or two-wire) that you will use. In general, you should not need to adjust the dBm.
If you want to turn on the audible alert (buzzer) for the orderwire, check the Buzzer On check box.
Step 4
Click Apply.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-A212 Create a User Data Channel Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In network view, click the Provisioning > Overhead Circuits tabs.
Step 1
Step 2 Click Create.
Cisco ONS 15454 Procedure Guide, R5.0
19-8
This task changes orderwire settings on the AIC-I card.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
This task creates a user data channel (UDC) circuit on the ONS 15454. A
UDC circuit allows you to create a dedicated data channel between nodes.
OC-N cards must be installed.
NTP-A24 Verify Card Installation, page 4-2
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Chapter 19 DLPs A200 to A299
September 2005