Figure - Cisco ONS 15454 Series Procedure Manual

Chapter 8 Monitor Performance
NTP-A122 Monitor Electrical Performance
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with
For DS3XM-12 cards complete the following procedures:
Step 2
•
•
For all other electrical cards continue with
Step 3 In node view, double-click the electrical card where you want to view PM counts. The card view appears.
Step 4 Click the Performance tab
December 2004
This procedure enables you to view node near-end or far-end
performance during selected time intervals on an electrical card and port
to detect possible performance problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and VT Tunnels"
As needed
Onsite or remote
Retrieve or higher
"DLP-A60 Log into CTC" task on page 17-66
DLP-A394 View DS-N/SONET PM Parameters for the DS3XM-12 Card, page 20-91
DLP-A395 View BFDL PM Parameters for the DS3XM-12 Card, page 20-93

(Figure

and Chapter 11, "Change Card Settings."
at the node that you want to monitor. If you
Step 3.
Step 3.
8-1).
Cisco ONS 15454 Procedure Guide, R5.0
NTP-A122 Monitor Electrical Performance
Chapter 6, "Create Circuits
8-3