Dlp- A341 Create An Ip-Encapsulated Tunnel - Cisco ONS 15454 Series Procedure Manual

DLP-A341 Create an IP-Encapsulated Tunnel
DLP-A341 Create an IP-Encapsulated Tunnel
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Each ONS 15454 can have up to ten IP-encapsulated tunnel connections. Terminated SDCCs used by the
ONS 15454 cannot be used as a tunnel endpoint, and a SDCC that is used as a tunnel endpoint cannot
be terminated. All tunnel connections are bidirectional.
Step 1 Verify that IP addresses are provisioned at both the source and destination nodes of the planned tunnel.
For more information, see the
Step 2 In network view, click the Provisioning > Overhead Circuits tabs.
Step 3 Click Create.
In the Overhead Circuit Creation dialog box, complete the following in the Circuit Attributes area:
Step 4
•
•
•
Click Next.
Step 5
In the Circuit Source area, complete the following:
Step 6
•
•
•
•
Click Next.
Step 7
In the Circuit Destination area, complete the following:
Step 8
•
•
•
•
Click Finish.
Step 9
Step 10 Put the ports that are hosting the IP-encapsulated tunnel in service. See the
Service State for a Port" task on page 19-9
Cisco ONS 15454 Procedure Guide, R5.0
20-32
This task creates a an IP-encapsulated tunnel to transport traffic from
third-party SONET equipment across ONS 15454 networks.
IP-encapsulated tunnels are created on the SDCC channel (D1-D3) (if not
used by the ONS 15454 as a terminated DCC).
OC-N cards must be installed.
NTP-A35 Verify Node Turn-Up, page 5-2
As needed
Onsite or remote
Provisioning or higher
Name—Type the tunnel name.
Type—Choose IP Tunnel-D1-D3.
Maximum Bandwidth—Type the percentage of total SDCC bandwidth used in the IP tunnel (the
minimum percentage is 10 percent).
Node—Choose the source node.
Slot—Choose the source slot.
Port—If displayed, choose the source port.
Channel—Displays IPT (D1-D3).
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If displayed, choose the destination port.
Channel—Displays IPT (D1-D3).
"DLP-A249 Provision IP Settings" task on page
for instructions.
Chapter 20 DLPs A300 to A399
19-30.
"DLP-A214 Change the
March 2005