Cisco ONS 15454 Series Procedure Manual page 615

Chapter 19 DLPs A200 to A299
Hello Interval (sec)—Sets the number of seconds between OSPF hello packet advertisements sent
•
by OSPF routers. Ten seconds is the default.
Dead Interval—Sets the number of seconds that will pass while an OSPF router's packets are not
•
visible before its neighbors declare the router down. Forty seconds is the default.
Transit Delay (sec)—Indicates the service speed. One second is the default.
•
Retransmit Interval (sec)—Sets the time that will elapse before a packet is resent. Five seconds is
•
the default.
LAN Metric—Sets a cost for sending packets across the LAN. This value should always be lower
•
than the DCC metric. Ten is the default.
Under OSPF Area Range Table, create an area range table if one is needed:
Step 6
Note
Under OSPF Area Range Table, click Create.
a.
In the Create Area Range dialog box, enter the following:
b.
•
•
•
•
Click OK.
c.
All OSPF areas must be connected to area 0. If the ONS 15454 OSPF area is not physically connected
Step 7
to area 0, use the following steps to create a virtual link table that will provide the disconnected area with
a logical path to area 0:
Under OSPF Virtual Link Table, click Create.
a.
In the Create Virtual Link dialog box, complete the following fields. OSPF settings must match
b.
OSPF settings for the ONS 15454 OSPF area:
•
•
•
•
•
•
Click OK.
c.
After entering ONS 15454 OSPF area data, click Apply.
Step 8
September 2005
Area range tables consolidate the information that is outside an OSPF area border. One
ONS 15454 in the ONS 15454 OSPF area is connected to the OSPF router. An area range table
on this node points the router to the other nodes that reside within the ONS 15454 OSPF area.
Range Address—Enter the area IP address for the ONS 15454s that reside within the OSPF area.
For example, if the ONS 15454 OSPF area includes nodes with IP addresses 10.10.20.100,
10.10.30.150, 10.10.40.200, and 10.10.50.250, the range address would be 10.10.0.0.
Range Area ID—Enter the OSPF area ID for the ONS 15454s. This is either the ID in the DCC
OSPF Area ID field or the ID in the Area ID for LAN Port field.
Mask Length—Enter the subnet mask length. In the Range Address example, this is 16.
Advertise—Check if you want to advertise the OSPF range table.
Neighbor—The router ID of the area 0 router.
Transit Delay (sec)—The service speed. One second is the default.
Hello Int (sec)—The number of seconds between OSPF hello packet advertisements sent by
OSPF routers. Ten seconds is the default.
Auth Type—If the router where the ONS 15454 is connected uses authentication, choose
Simple Password. Otherwise, choose No Authentication.
Retransmit Int (sec)—Sets the time that will elapse before a packet is resent. Five seconds is the
default.
Dead Int (sec)—Sets the number of seconds that will pass while an OSPF router's packets are
not visible before its neighbors declare the router down. Forty seconds is the default.
DLP-A250 Set Up or Change Open Shortest Path First Protocol
Cisco ONS 15454 Procedure Guide, R5.0
19-35