Ntp- A298 Reconfigure Circuits - Cisco ONS 15454 Series Procedure Manual

Chapter 9 Manage Circuits
d.
e.
Note
After you set up the path trace, the received string appears in the Received field on the path trace setup
Step 11
window. The following options are available:
•
•
•
Clicking Default will generate alarms if the port on the other end is provisioned with a different string.
Caution
The expect and receive strings are updated every few seconds if the Path Trace Mode field is set to Auto
or Manual.
Click Close.
Step 12
The detailed circuit window indicates path trace with an M (manual path trace) or an A (automatic path
trace) at the circuit source and destination ports.
Stop. You have completed this procedure.
NTP-A298 Reconfigure Circuits
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Click the Circuits tab.
Step 2
Choose the circuits that you want to reconfigure.
Step 3
From the Tools menu, choose Circuits > Reconfigure Circuits.
Step 4
In the confirmation dialog box, click Yes to continue.
Step 5
December 2004
(Check box visibility depends on card selection.) Click the Disable AIS on C2 Mis-Match check
box if you want to suppress the AIS when a C2 mismatch occurs.
Click Apply.
It is not necessary to set the format (16 or 64 bytes) for the circuit source expected string; the
path trace process automatically determines the format.
Click Hex Mode to display path trace in hexadecimal format. The button name changes to ASCII
Mode. Click it to return the path trace to ASCII format.
Click the Reset button to reread values from the port.
Click Default to return to the path trace default settings (Path Trace Mode is set to Off and the
New Transmit and New Expected Strings are null).
This procedure rebuilds circuits, which might be necessary when a large
number of circuits are in the PARTIAL status.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page
NTP-A298 Reconfigure Circuits
17-66. If you are already logged in, continue with
Cisco ONS 15454 Procedure Guide, R5.0
9-9