Dlp- A368 Delete A Provisionable Patchcord - Cisco ONS 15454 Series Procedure Manual

DLP-A368 Delete a Provisionable Patchcord
In the Origination Node area, complete the following:
Step 3
a.
b.
c.
In the Termination Node area, complete the following:
Step 4
a.
b.
c.
If you need to provision Tx and Rx separately for multiplexer/demultiplexer cards, check the
Step 5
Separate Tx/Rx check box. If not, continue with
already provisioned. Complete the following to provision the RX ports:
a.
b.
c.
d.
Click OK.
Step 6
If you provisioned a patchcord on a port in a 1+1 protection group, a dialog box appears to ask if you
Step 7
would like to provision the peer patchcord. Click Yes. Repeat Steps
Return to your originating procedure (NTP).
Step 8
DLP-A368 Delete a Provisionable Patchcord
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting the last DCC termination on an optical port automatically deletes all provisionable patchcords
Note
provisioned on the port. If the port is in a 1+1 protection group, CTC automatically deletes the patchcord
link on the protection port.
Cisco ONS 15454 Procedure Guide, R5.0
20-52
If you are in node view, the Origination Node defaults to the current node. If you are in network
view, click the desired origination node from the drop-down list.
Type a patchcord identifier (0 through 32767) in the TX/RX ID field.
Click the desired origination slot/port from the list of available slots/ports.
Click the desired termination node from the drop-down list. If the remote node has not previously
been discovered by CTC but is accessible by CTC, type the name of the remote node.
Type a patchcord identifier (0 through 32767) in the TX/RX ID field. The origination and
termination IDs must be different if the patchcord is set up between two cards on the same node.
Click the desired termination slot/port from the list of available slots/ports. The origination port and
the termination port must be different.
In the Origination Node area, type a patchcord identifier (0 through 32767) in the RX ID field. The
origination TX and RX IDs and termination TX and RX IDs must be different.
Click the desired origination slot/port from the list of available slots/ports.
In the Termination Node area, type a patchcord identifier (0 through 32767) in the RX ID field. The
origination TX and RX IDs and termination TX and RX IDs must be different.
Click the desired termination slot/port from the list of available slots/ports.
This task deletes a provisionable patchcord.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Step 6. The origination and termination TX ports are
3 through 6.
Chapter 20 DLPs A300 to A399
March 2005