Dlp- A121 Enable/Disable Pointer Justification Count Performance Monitoring - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
DLP-A121 Enable/Disable Pointer Justification Count Performance
Monitoring
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card you want to monitor. The card view appears.
Step 1
See
Table 18-1
Line Terminating Equipment
EC1-12
OC3 IR 4/STM1 SH 1310
OC3 IR4/STM1 SH 1310-8
OC12 LR/STM4 LH 1310
OC12 IR/STM4 SH 1310
OC12 IR/STM4 SH 1310-4
OC12 LR/STM4 LH 1550
OC48 LR 1550
OC48 IR 1310
OC48 LR/STM16 LH AS 1550
OC48 IR/STM16 SH AS 1310
OC48 ELR 200 GHz
OC48 ELR/STM16 EH 100 GHz
OC192 SR/STM64 IO 1310
OC192 IR/STM64 SH 1550
OC192 LR/STM64 LH 1550
OC192 ELR/STM64 LH ITU 15xx.xx
Click the Provisioning > Line tabs.
Step 2
From the PJSTSMon# drop-down list, make a selection based on the following rules
Step 3
•
March 2007
Table 18-1 for a list of line terminating equipment (LTE) cards.
OC-N Cards that Terminate the Line, Called LTEs
Off means pointer justification monitoring is disabled (default).
DLP-A121 Enable/Disable Pointer Justification Count Performance Monitoring
This task enables or disables pointer justification counts, which provide
a way to align the phase variations in synchronous transport signal
(STS) payloads and to monitor the clock synchronization between
nodes. A consistently large pointer justification count indicates clock
synchronization problems between nodes.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15454 Procedure Guide, R5.0
(Figure 18-4):
18-7