Ntp- A182 Create A Manually Routed Ds-1 Circuit - Cisco ONS 15454 Series Procedure Manual

NTP-A182 Create a Manually Routed DS-1 Circuit
Create cross-connects only (TL1-like)—Check this box if you want to create one or more
•
cross-connects to complete a signal path for TL1-generated circuits. Also, VT tunnels and
Ethergroup sources and destinations are unavailable.
State—Choose the administrative state to apply to all of the cross-connects in a circuit:
•
–
–
–
–
For additional information about circuit service states, refer to the "Circuits and Tunnels" chapter
in the Cisco ONS 15454 Reference Manual.
Apply to drop ports—Check this check box if you want to apply the administrative state chosen in
•
the State field to the circuit source and destination ports. CTC applies the administrative state to the
ports only if the circuit bandwidth is the same as the port bandwidth or, if the port bandwidth is
larger than the circuit, the circuit must be the first circuit to use the port. If not, a Warning dialog
box displays the ports where the administrative state could not be applied. If the check box is
unchecked, CTC does not apply the administrative state of the source and destination ports.
Note
• Protected Drops—Check this box if you want the circuit routed on protected drops only, that is, to
ONS 15454 cards that are in 1:1, 1:N, 1+1, or optimized 1+1 protection. If you check this box, CTC
shows only protected cards and ports as source and destination choices.
If the circuit will be routed on a path protection, complete the
Step 8
Selectors" task on page
Step 9 Click Next.
Step 10 Complete the
Step 11 In the Circuit Routing Preferences area
To set the circuit path protection, complete one of the following:
Step 12
To route the circuit on a protected path, leave Fully Protected Path checked and continue with
•
Step
and alternate paths), and the path diversity options apply only to path protection path segments, if
any exist.
• To create an unprotected circuit, uncheck Fully Protected Path and continue with
To route the circuit on a BLSR protection channel, if available, uncheck Fully Protected Path,
•
check Protection Channel Access, click Yes in the Warning dialog box, then continue with
Cisco ONS 15454 Procedure Guide, R5.0
6-12
IS—Puts the circuit cross-connects in the IS-NR service state.
OOS,DSBLD—Puts the circuit cross-connects in the OOS-MA,DSBLD service state. Traffic is
not passed on the circuit.
IS,AINS—Puts the circuit cross-connects in the OOS-AU,AINS service state and suppresses
alarms and conditions. When the connections receive a valid signal, the service state
automatically changes to IS-NR.
OOS,MT—Puts the circuit cross-connects in the OOS-MA,MT service state. The maintenance
state does not interrupt traffic flow; it suppresses alarms and conditions and allows loopbacks
to be performed on the circuit. Use OOS,MT for circuit testing or to suppress circuit alarms
temporarily. Change the administrative state to IS; IS,AINS; or OOS,DSBLD when testing is
complete. See the "DLP-A230 Change a Circuit Service State" task on page
Loss of signal alarms are generated if ports in the IS-NR service state are not receiving
signals.
19-12. Otherwise, continue with the next step.
"DLP-A95 Provision a DS-1 Circuit Source and Destination" task on page
13. Fully protected paths might or might not have path protection path segments (with primary
"DLP-A218 Provision Path Protection
(Figure 6-2 on page 6-9), uncheck Route Automatically.
Chapter 6 Create Circuits and VT Tunnels
19-19.
17-96.
Step 16.
August 2005
Step 16.