Dlp- A163 Delete Snmp Trap Destinations - Cisco ONS 15454 Series Procedure Manual

DLP-A163 Delete SNMP Trap Destinations
DLP-A163 Delete SNMP Trap Destinations
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > SNMP tabs.
Step 1
In the Trap Destinations area, click the trap you want to delete.
Step 2
Click Delete. A confirmation dialog box appears.
Step 3
Click Yes. Confirm that the changes appear; if not, repeat the task.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-A165 Change Line and Threshold Settings for the DS1-14 or DS1N-14
Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the node view, double-click the DS1-14 or DS1N-14 card where you want to change the line or
Step 1
threshold settings.
Click the Provisioning tab.
Step 2
Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
Step 3
or SONET Thresholds tab.
Note
Modify any of the settings found under these subtabs. For definitions of the Line settings, see
Step 4
For definitions of the Line Threshold settings, see
Threshold settings, see
Click Apply.
Step 5
Cisco ONS 15454 Procedure Guide, R5.0
18-28
This task deletes Simple Network Management Protocol (SNMP) trap
destinations on an ONS 15454.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
This task changes the line and threshold settings for the DS1-14 or
DS1N-14 (DS-1) cards.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
See Chapter 7, "Manage Alarms"
Table 18-5. For definitions of the SONET Threshold settings, see
for information about the Alarm Behavior tab.
Table 18-4. For definitions of the Electrical Path
Chapter 18 DLPs A100 to A199
Table 18-3.
Table 18-6.
March 2007