Ntp- A15 Install The Common Control Cards - Cisco ONS 15454 Series Procedure Manual

NTP-A15 Install the Common Control Cards
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement
1029
NTP-A15 Install the Common Control Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
If you install a card incorrectly, the FAIL LED flashes continuously.
Note
Step 1 If you plan to install XCVT cards, review
install XC10G cards, review
Step 2 Complete the
Complete the
Step 3
Complete the
Step 4
Controller–International Card" task on page
Note
Cisco ONS 15454 Procedure Guide, R5.0
2-2
This procedure describes how to install the common control cards.
Redundant TCC2/TCC2P cards
Redundant XCVT or XC10G (cross-connect) cards
AIC/AIC-I card (optional)
NTP-A13 Perform the Shelf Installation Acceptance Test, page 1-30
Required
Onsite
Provisioning or higher
Table 2-2 on page 2-5
"DLP-A36 Install the TCC2/TCC2P Cards" task on page
"DLP-A37 Install the XCVT or XC10G Cards" task on page
"DLP-A38 Install the Alarm Interface Controller or Alarm Interface
If you install the wrong card in a slot, see the
procedure on page 2-17.
Chapter 2
Table 2-1 to determine card/slot compatibility. If you plan to
to determine card/slot compatibility.
17-47, as needed.
"NTP-A116 Remove and Replace a Card"
Install Cards and Fiber-Optic Cable
17-42.
17-45.
May 2006