Figure - Cisco ONS 15454 Series Procedure Manual

DLP-A121 Enable/Disable Pointer Justification Count Performance Monitoring
1 to n are the number of STSs on the port. One STS per port can be enabled from the PJSTSMon#
•
card drop-down list.

Figure 18-4

Card View
Provisioning
Line tab
In the Service State field, confirm that the port is in the In-Service and Normal (IS-NR) service state.
Step 4
If the port is IS-NR, click Apply. If the port in the Out-of-Service and Management, Disabled
Step 5
(OOS-MA,DSBLD), OOS-MA,MT, or the Out-of-Service and Autonomous, Automatic In-Service
(OOS-AU,AINS) service state, choose IS from the Admin State drop-down list and click Apply.
Click the Performance tab to view performance monitoring (PM) parameters. For PM parameter
Step 6
definitions, refer to the "Performance Monitoring" chapter in the Cisco ONS 15454 Troubleshooting
Guide.
Note
Return to your originating procedure (NTP).
Step 7
Cisco ONS 15454 Procedure Guide, R5.0
18-8
Enabling or Disabling Pointer Justification Count Parameters
tab
The count fields for PPJC and NPJC PM parameters appear white and blank unless pointer
justification count performance monitoring is enabled.
Chapter 18 DLPs A100 to A199
PJSTSMon#
drop-down list button
March 2007
Apply