Dlp- A112 Display Alarms And Conditions Using Time Zone - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
DLP-A112 Display Alarms and Conditions Using Time Zone
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Edit menu, choose Preferences.
Step 1
The CTC Preferences dialog box appears
Check the Display Events Using Each Node's Timezone check box. The Apply button is enabled.
Step 2
Click Apply and OK.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-A113 Synchronize Alarms
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At the card, node, or network view, click the Alarms tab.
Step 1
Click Synchronize.
Step 2
This button causes CTC to retrieve a current alarm summary for the card, node, or network. This step is
optional because CTC updates the Alarms window automatically as raise/clear messages arrive from the
node.
Note
Return to your originating procedure (NTP).
Step 3
March 2007
This task changes the time stamp for events to the time zone of the ONS
node reporting the alarm. By default, the events time stamp is set to the
time zone for the CTC workstation.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
This task is used to view ONS 15454 events at the card, node, or network
level and to refresh the alarm listing so that you can check for new and
cleared alarms and conditions.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
Alarms that have been raised during the session will have a check mark in the Alarms window
New column. When you click Synchronize, the check mark disappears.
DLP-A112 Display Alarms and Conditions Using Time Zone
(Figure 18-1 on page 18-2).
Cisco ONS 15454 Procedure Guide, R5.0
18-3