Dlp- A266 Change Ip Settings - Cisco ONS 15454 Series Procedure Manual

Chapter 19 DLPs A200 to A299
Table 19-4
Code


<u>
</u>
If you want to preview your changed statement and formatting, click the Preview subtab.
Step 3
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-A266 Change IP Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Changing the node IP address, subnet mask, or IIOP listener port causes the TCC2/TCC2P cards to
Caution
reboot. If Ethernet circuits using Spanning Tree Protocol (STP) originate or terminate on E-Series
Ethernet cards installed in the node, circuit traffic will be lost for several minutes while the spanning
trees reconverge. Other circuits are not affected by TCC2/TCC2P reboots.
In node view, click the Provisioning > Network > General tabs.
Step 1
Change any of the following:
Step 2
•
•
•
•
•
•
September 2005
HTML Tags for the Login Legal Disclaimer (continued)
This task changes the IP address, subnet mask, default router, DHCP
access, firewall IIOP listener port, LCD IP display, and the SOCKS proxy
server settings.
None
DLP-A60 Log into CTC, page 17-66
DLP-A249 Provision IP Settings, page 19-30
As needed
Onsite or remote
Superuser
IP Address
Suppress CTC IP Display
LCD IP Setting
Default Router
Forward DHCP Request To
Net/Subnet Mask Length
Description
Begins subscript
Ends subscript
Begins superscript
Ends superscript
Starts underline
Ends underline
Cisco ONS 15454 Procedure Guide, R5.0
DLP-A266 Change IP Settings
19-51