Ntp- A250 Monitor Oc-N Performance - Cisco ONS 15454 Series Procedure Manual

NTP-A250 Monitor OC-N Performance
Complete the
Step 1
Step 2.
Perform any of the following tasks as needed:
Step 2
•
•
Stop. You have completed this procedure.
NTP-A250 Monitor OC-N Performance
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with
Complete the
Step 2
page 18-7
Complete the
Step 3
page 18-9
Complete the
Step 4
To refresh, reset, or clear PM counts, see the
page
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
8-6
"DLP-A60 Log into CTC" task on page
DLP-A533 Create Ethernet RMON Alarm Thresholds, page 22-28
DLP-A529 Delete Ethernet RMON Alarm Thresholds, page 22-26
This procedure enables you to view node near-end or far-end
performance during selected time intervals on an OC-N card and port to
detect possible performance problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and VT Tunnels"
As needed
Onsite or remote
Retrieve or higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A121 Enable/Disable Pointer Justification Count Performance Monitoring" task on
as needed to enable or disable clock synchronization monitoring.
"DLP-A122 Enable/Disable Intermediate Path Performance Monitoring" task on
as needed to enable or disable monitoring of STS traffic through intermediate nodes.
"DLP-A507 View OC-N PM Parameters" task on page
8-2.
17-66. If you are already logged in, continue with
and Chapter 11, "Change Card Settings."
at the node that you want to monitor. If you
Step 2.
"NTP-A253 Change the PM Display" procedure on
Chapter 8 Monitor Performance
Chapter 6, "Create Circuits
22-1.
December 2004