Dlp- A53 Set Up A Solaris Workstation For A Craft Connection To An Ons 15454 - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

Chapter 17
DLPs A1 to A99
i.
j.
If you have Windows XP installed on your PC, complete the following steps to change its TCP/IP
Step 6
configuration:
a.
b.
c.
d.
e.
f.
g.
h.
i.
Return to your originating procedure (NTP).
Step 7
DLP-A53 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Log into the workstation as the root user.
Step 1
Check to see if the interface is plumbed by typing:
Step 2
# ifconfig device
For example:
# ifconfig hme1
If the interface is plumbed, a message similar to the following appears:
hme1:flags=1000842<BROADCAST,RUNNING,MULTICAST,IPv4>mtu 1500 index 2 inet 0.0.0.0 netmask 0
If a message similar to this one appears, go to
March 2005
In the Local Area Connection Properties dialog box, click OK.
In the Local Area Connection Status dialog box, click Close.
From the Windows Start menu, choose Control Panel > Network Connections.
If the Network Connections menu item is not available, click Switch to Classic View.
Note
From the Network Connections dialog box, click the Local Area Connection icon.
From the Local Area Connection Properties dialog box, choose Internet Protocol (TCP/IP), then
click Properties.
In the IP Address field, enter any legitimate IP address other than the node IP address.
In the Subnet Mask field, type the same subnet mask as the ONS 15454. The default is
255.255.255.0 (24 bit).
Type the IP address entered in Step
Click OK.
In the Local Area Connection Properties dialog box, click OK.
In the Local Area Connection Status dialog box, click Close.
This task sets up a Solaris workstation for a craft connection to the
ONS 15454.
None
NTP-A260 Set Up Computer for CTC, page 3-1
As needed
Onsite
None
DLP-A53 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454
d
in the Gateway Address field.
Step
4.
Cisco ONS 15454 Procedure Guide, R5.0
17-63

Advertisement

Table of Contents
loading

Table of Contents