Table 1-1 Pin Assignments For The Aep; Ntp- A8 Attach Wires To Alarm, Timing, Lan, And Craft Pin Connections - Cisco ONS 15454 Series Procedure Manual

Chapter 1 Install the Shelf and Backplane Cable
Table 1-1
AEP Cable Wire
Black
White
Slate
Violet
Blue
Green
Yellow
Orange
Red
Brown
Continue with the
Step 6
procedure on page
Stop. You have completed this procedure.
NTP-A8 Attach Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed.
Step 1 Complete the
AIC or AIC-I card and are not using an AEP.
Step 2 Complete the
wires are necessary to provision external timing.
Step 3 Complete the
(or the LAN port on the TCC2/TCC2P) are necessary to create an external LAN connection.
March 2005
Pin Assignments for the AEP
Backplane Pin AIC-I Signal
A1 GND
A2 AE_+5
A3 VBAT–
A4 VB+
A5 AE_CLK_P
A6 AE_CLK_N
A7 AE_DIN_P
A8 AE_DIN_N
A9 AE_DOUT_P
A10 AE_DOUT_N
"NTP-A8 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections"
1-15.
This procedure describes how to install alarm, timing, LAN, and craft
wires.
Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) alarm wires
NTP-A4 Remove the Backplane Covers, page 1-7
As needed
Onsite
None
"DLP-A19 Install Alarm Wires on the Backplane" task on page 17-22
"DLP-A20 Install Timing Wires on the Backplane" task on page 17-25
"DLP-A21 Install LAN Wires on the Backplane" task on page 17-26
NTP-A8 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections
AEP Signal
AEP_GND
AEP_+5
VBAT–
VB+
AE_CLK_P
AE_CLK_N
AE_DOUT_P
AE_DOUT_N
AE_DIN_P
AE_DIN_N
Cisco ONS 15454 Procedure Guide, R5.0
if you are using an
as needed. Timing
as needed. LAN wires
1-15