Dlp- A12 Install A Bnc Or High-Density Bnc Eia - Cisco ONS 15454 Series Procedure Manual

DLP-A12 Install a BNC or High-Density BNC EIA
DLP-A12 Install a BNC or High-Density BNC EIA
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Remove the BNC or high-density BNC card from the packaging. Line up the connectors on the card with
Step 1
the mating connectors on the backplane. Gently push the card until both sets of connectors fit together
snugly.
Place the metal EIA panel over the card.
Step 2
Insert and tighten the nine perimeter screws (P/N 48-0358) at 8 to 10 lb (3.6 to 4.5 kg) to secure the cover
Step 3
panel to the backplane.
Insert and tighten the twelve (BNC) or nine (high-density BNC) inner screws (P/N 48-0004) at 8 to 10 lb
Step 4
(3.6 to 4.5 kg) to secure the cover panel to the card and backplane.
Figure 17-5
Cisco ONS 15454 Procedure Guide, R5.0
17-12
This task installs a BNC or high-density BNC EIA. Use this task if you are
using DS3-12, DS3XM-6, or EC-1 cards and prefer a BNC interface to an
SMB interface.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Perimeter screws (9)
Inner screws (12)
Backplane cover screws (5)
BNC or high-density BNC card
NTP-A4 Remove the Backplane Covers, page 1-7
As needed
Onsite
None
shows a BNC EIA installation.
Chapter 17 DLPs A1 to A99
March 2005