Dlp- A214 Change The Service State For A Port - Cisco ONS 15454 Series Procedure Manual

Chapter 19 DLPs A200 to A299
In the Overhead Circuit Creation dialog box, complete the following fields in the Circuit Attributes area:
Step 3
•
•
Click Next.
Step 4
In the Circuit Source area, complete the following:
Step 5
•
•
•
Step 6 Click Next.
In the Circuit Destination area, complete the following:
Step 7
•
•
•
Click Finish.
Step 8
Return to your originating procedure (NTP).
Step 9
DLP-A214 Change the Service State for a Port
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To provision E-Series Ethernet ports, see the
Note
page
In node view on the shelf graphic, double-click the card with the ports you want to put in or out of
Step 1
service. The card view appears.
Click the Provisioning > Line tabs for all cards except the G-Series cards. For the G-Series cards,
Step 2
choose the Provisioning > Port tabs.
In the Admin State column for the target port, choose one of the following from the drop-down list:
Step 3
•
September 2005
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces).
Type—Choose either User Data-F1 or User Data D-4-D-12 from the drop-down list.
(User Data D-4-D-12 is not available if the ONS 15454 is provisioned for DWDM.)
Node—Choose the source node.
Slot—Choose the source slot.
Port—If displayed, choose the source port.
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If displayed, choose the destination port.
This task changes the port service state.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
19-13.
IS—Puts the port in the In-Service and Normal (IS-NR) service state.
DLP-A214 Change the Service State for a Port
"DLP-A220 Provision E-Series Ethernet Ports" task on
Cisco ONS 15454 Procedure Guide, R5.0
19-9