Dlp- A25 Install Coaxial Cable With Bnc Connectors - Cisco ONS 15454 Series Procedure Manual

DLP-A25 Install Coaxial Cable With BNC Connectors
DLP-A25 Install Coaxial Cable With BNC Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Place the BNC cable connector over the desired connection point on the backplane.
Figure 17-15
connector.
Figure 17-15
Position the cable connector so that the slot in the connector is over the corresponding notch at the
Step 2
backplane connection point.
Gently push the connector down until the notch backplane connector slides into the slot on the cable
Step 3
connector.
Turn the cable connector clockwise to lock it into place.
Step 4
Tie wrap or lace the cables to the EIA according to Telcordia standards (GR-1275-CORE) or local site
Step 5
practice.
Route the cables to the nearest side of the shelf assembly through the side cutouts according to local site
Step 6
practice. The rubber-coated edges of the side cutouts prevent the cables from chafing.
Cisco ONS 15454 Procedure Guide, R5.0
17-32
This task installs the coaxial cable with BNC connectors.
None
DLP-A12 Install a BNC or High-Density BNC EIA, page 17-12
As needed
Onsite
None
shows how to connect a coaxial cable to the BNC EIA using a right-angle BNC cable
Using a Right-Angle Connector to Install Coaxial Cable with BNC Connectors
Chapter 17 DLPs A1 to A99
March 2005