Cisco ONS 15454 Series Procedure Manual page 174

NTP-A181 Create an Automatically Routed DS-1 Circuit
f.
g.
h.
i.
j.
k.
Repeat
Step 7
Complete the appropriate circuit creation procedure from the NTP list in the
Step 8
on page
Stop. You have completed this procedure.
NTP-A181 Create an Automatically Routed DS-1 Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
From the View menu, choose Go to Network View.
Step 3
Click the Circuits tab, then click Create.
Step 4
In the Circuit Creation dialog box, complete the following fields:
Step 5
Cisco ONS 15454 Procedure Guide, R5.0
6-6
Click the Security tab. Verify that the users and access levels are provisioned as specified. If not,
see the "NTP-A30 Create Users and Assign Security" procedure on page 4-4
information.
If Simple Network Management Protocol (SNMP) is used, click the SNMP tab and verify the trap
and destination information. If the information is not correct, see the
Settings" procedure on page 10-6
Click the Comm Channels tab. Verify that DCCs were created to the applicable OC-N slots and
ports (time-division multiplexing [TDM] nodes) or Optical Service Channel (OSC) slots and ports
(DWDM nodes). If DCCs were not created for the appropriate OC-N or OSC slots and ports, see
Chapter 5, "Turn Up Network"
topology.
Click the Timing tab. Verify that timing is provisioned as specified. If not, use the
Change Node Timing" procedure on page 10-5
Click the Alarm Profiles tab. If you provisioned optional alarm profiles, verify that the alarms are
provisioned as specified. If not, see the
Profiles" procedure on page 7-7
Verify that the network element defaults listed in the status area of the node view window are
correct.
Step 6 for each node in the network.
6-1.
This procedure creates an automatically routed DS-1 circuit, meaning that
CTC chooses the circuit route based on the parameters you specify and on
the software version.
None
NTP-A127 Verify Network Turn Up, page 6-4
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A314 Assign a Name to a Port" task on page
to correct the information.
and complete the turn-up procedure appropriate for your network
to make the changes.
"NTP-A71 Create, Download, and Assign Alarm Severity
to change the information.
at the node where you will create the circuit.
Step 2.
Chapter 6 Create Circuits and VT Tunnels
to correct the
"NTP-A87 Change SNMP
"NTP-A85
"Before You Begin" section
20-8. If not, continue with Step 3.
August 2005