Figure 5-13 Blsr Subtended From A Blsr; Ntp- A48 Subtend A Blsr From A Blsr - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:

Table of Contents

Turn Up Network

BLSR Subtended from a BLSR

Attach fibers from the trunk cards in the subtending node to the BLSR trunk cards on its two neighboring

BLSR nodes. In

Node 5/Slot 6. See the

Create the DCCs on the first OC-N card that will carry the BLSR. See the

DCC Terminations" task on page

management, complete

Complete the

the BLSR. If you have already provisioned the BLSR, perform this procedure for the subtending node

If the subtending BLSR is not already created, complete the

the ring name of the first BLSR.

From the View menu, choose Go to Network View to see the subtending ring.

December 2004

5-13, Node 4/Slot 6 connects to Node 7/Slot 13, and Node 4/Slot 13 connects to

"DLP-A44 Install Fiber-Optic Cables for BLSR Configurations" task on

the"DLP-A378 Provision Line DCC Terminations" task on page

for the second OC-N trunk card that will carry the BLSR.

"NTP-A40 Provision BLSR Nodes" procedure on page 5-10

to provision the new BLSR. The subtending BLSR must have a ring name that differs from

The subtending node can have one Node ID that is used in both BLSRs, or a different Node ID

for each BLSR. For example, the same node can be Node 4 in BLSR 1 and Node 2 in BLSR 2.

shows an example of two subtending BLSRs.

20-61. Alternatively, if additional bandwidth is needed for CTC

Cisco ONS 15454 Procedure Guide, R5.0

NTP-A48 Subtend a BLSR from a BLSR

"DLP-A377 Provision Section

for each node that will be in

"NTP-A126 Create a BLSR" procedure on

Chapters

Table of Contents