Ntp- A126 Create A Blsr - Cisco ONS 15454 Series Procedure Manual

Chapter 5 Turn Up Network
NTP-A175 Two-Fiber BLSR Acceptance Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note This procedure requires that you create test circuits and perform ring switches around the ring. For
clarity, "Node 1" refers to the login node where you begin the procedure. "Node 2" refers to the node
connected to the east OC-N trunk (span) card of Node 1.
Complete the
Step 1
are testing. (This node will be called Node 1.) If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Step 3 Click the Alarms tab.
a.
b.
c.
Step 4 Click the Conditions tab.
a.
b.
Step 5 On the network view, double-click Node 1.
Complete the
Step 6
Create a test circuit from Node 1 to the node connected to the east OC-N trunk (span) card of Node 1.
Step 7
(This node will be called Node 2.)
•
•
•
December 2004
This procedure tests a two-fiber BLSR.
Test set and cables appropriate for the test circuit
NTP-A40 Provision BLSR Nodes, page 5-10
NTP-A126 Create a BLSR, page 5-12
As needed
Onsite
Provisioning and higher
"DLP-A60 Log into CTC" task on page 17-66
Verify that the alarm filter is not on. See the
page 19-17 as necessary.
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
Complete the "DLP-A516 Export CTC Data" task on page 22-6
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
Complete the "DLP-A516 Export CTC Data" task on page 22-6
information.
"DLP-A217 BLSR Exercise Ring Test" task on page
For DS-1 circuits, complete the
procedure on page 6-6. When you set the circuit state, choose IS and check the Apply to drop ports
check box.
For DS-3 circuits, complete the
procedure on page 6-18. When you set the circuit state, choose IS and check the Apply to drop
ports check box.
For OC-N circuits, complete the
procedure on page 6-38. When you set the circuit state, choose IS and check the Apply to drop
ports check box.
at one of the ONS 15454s on the BLSR you
"DLP-A227 Disable Alarm Filtering" task on
"NTP-A181 Create an Automatically Routed DS-1 Circuit"
"NTP-A184 Create an Automatically Routed DS-3 Circuit"
"NTP-A257 Create an Automatically Routed OC-N Circuit"
Cisco ONS 15454 Procedure Guide, R5.0
NTP-A175 Two-Fiber BLSR Acceptance Test
to export the alarm information.
to export the conditions
19-10.
5-13