Cisco ONS 15454 Series Procedure Manual page 107

Connect the PC and Log into the GUI
This chapter explains how to connect PCs and workstations to the Cisco ONS 15454 and how to log into
Cisco Transport Controller (CTC) software, which is the ONS 15454 Operation, Administration,
Maintenance and Provisioning (OAM&P) user interface. Procedures for connecting to the ONS 15454
using TL1 are provided in the Cisco ONS SONET TL1 Command Guide.
Before You Begin
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
NTP-A260 Set Up Computer for CTC
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note JRE 1.4.2 is required to log into nodes running Release 5.0. To log into nodes running Release 4.5 or
earlier, you must uninstall JRE 1.4.1 and install JRE 1.3.1_2.
December 2004
NTP-A260 Set Up Computer for CTC, page
workstation has never been connected to an ONS 15454.
NTP-A234 Set Up CTC Computer for Local Craft Connection to the ONS 15454, page
3-2—Complete this procedure to set up your computer for an onsite craft connection to the
ONS 15454.
NTP-A235 Set Up a CTC Computer for a Corporate LAN Connection to the ONS 15454, page
3-4—Complete this procedure to set up your computer to connect to the ONS 15454 using a
corporate LAN.
NTP-A236 Set Up a Remote Access Connection to the ONS 15454, page
procedure to set up your computer for remote modem access to the ONS 15454.
NTP-A23 Log into the ONS 15454 GUI, page
This procedure configures your PC or UNIX workstation to run CTC.
Cisco ONS 15454 Release 5.0 software or documentation CD
Chapter 1, "Install the Shelf and Backplane Cable"
Required
Onsite or remote
None
C H A P T E R
3-1—Complete this procedure if your PC or
3-6—Complete this procedure to log into CTC.
Cisco ONS 15454 Procedure Guide, R5.0
3
3-5—Complete this
3-1