Dlp- A167 Change Line And Threshold Settings For The Ds3-12E Or Ds3N-12E Cards - Cisco ONS 15454 Series Procedure Manual

DLP-A167 Change Line and Threshold Settings for the DS3-12E or DS3N-12E Cards
Table 18-10
Parameter
ES
FC
SES
UAS
Note
Return to your originating procedure (NTP).
Step 7
DLP-A167 Change Line and Threshold Settings for the DS3-12E or
DS3N-12E Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If the DS3E is installed in an ONS 15454 slot that is provisioned for a DS-3 card, the DS3E enhanced
Note
performance monitoring parameters are unavailable. If this occurs, remove the DS3E from the
ONS 15454, delete the DS-3 card in CTC using the
provision the slot for the DS3E using the
Double-click the DS3-12E or DS3N-12E card where you want to change the line or threshold settings.
Step 1
Click the Provisioning tab.
Step 2
Cisco ONS 15454 Procedure Guide, R5.0
18-36
SONET Threshold Options for DS3-12 or DS3N-12 Cards (continued)
Description
Errored seconds
Failure count
Severely errored seconds
Unavailable seconds
The threshold value appears after the circuit is created.
This task changes the line and threshold settings for the DS3E-12 or
DS3N-12E (DS3E) cards.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Options
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds (Near and Far
End, STS termination only).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds (Near and Far
End, STS termination only).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds (Near and Far
End, STS termination only).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds (Near and Far
End, STS termination only).
"DLP-A191 Delete a Card" task on page
"DLP-A330 Preprovision a Slot" task on page
Chapter 18 DLPs A100 to A199
18-65, and
20-20.
March 2007