Ntp- A310 Soft-Reset A Ce100T-8 Card Using Ctc - Cisco ONS 15454 Series Procedure Manual

NTP-A310 Soft-Reset a CE100T-8 Card Using CTC
Click Yes in the "Are you sure you want to hard-reset this card?" dialog box.
Step 8
Stop. You have completed this procedure.
NTP-A310 Soft-Reset a CE100T-8 Card Using CTC
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Soft-resetting the CE100T-8 card is errorless in most cases. If there is a provisioning change during the
soft reset, or if the firmware is replaced during the software upgrade process, the reset is not errorless.
Step 1 Complete the
CE100T-8 card reset. If you are already logged in, continue with
Step 2 Right-click the card to reveal a pop-up menu.
Click Soft-reset Card.
Step 3
Click Yes in the "Are you sure you want to soft-reset this card?" dialog box.
Step 4
Stop. You have completed this procedure.
NTP-A215 View G-Series Ethernet Maintenance Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step
In node view, double-click a G-Series Ethernet card. The card view appears.
Step 2
Cisco ONS 15454 Procedure Guide, R5.0
15-16
This procedure soft-resets the CE100T-8 card.
None
"NTP-A246 Install Ethernet Cards and Connectors" procedure on
page 2-10
As needed
Onsite or remote
Superuser
"DLP-A60 Log into CTC" task on page 17-66
This procedure enables you to view loopback, bandwidth, and J1 path
trace information for G-Series Ethernet cards.
None
NTP-A246 Install Ethernet Cards and Connectors, page 2-10
As needed
Onsite or remote
Retrieve or higher
"DLP-A60 Log into CTC" task on page
2.
Chapter 15
at the node where you want to perform the
Step 2.
17-66. If you are already logged in, continue with
Maintain the Node
December 2004