Ubic-V Slot Designations - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
Figure 20-14

UBIC-V Slot Designations

JACKSCREW SHOULD BE
B
INSTALLED FIRST AND
REMOVED LAST
(SLOT 17)(SLOT 16)(SLOT 15)
DS1/DS3
P
TX
LD
P
RX
HD(SLOT 17) HD(SLOT 16)
J17 J20 J21 J23
REAR COVER
Rx
BRACKET
LOCATION
HD(SLOT 17) HD(SLOT 16)
J25 J28 J29 J31
HD(SLOT 16) HD(SLOT 17)
J24 J22 J19 J18
Rx
HD(SLOT 16) HD(SLOT 17)
J32 J30 J27 J26
(SLOT 14)(SLOT 13)(SLOT 12)
TX
LD
RX
REAR COVER
BRACKET
LOCATION
Step 2 With the alignment slots of the cable connector aligned with the alignment standoffs of the UBIC
connector, carefully install the cable.
Step 3 Use the flat-head screwdriver to tighten the screw at the top left of the cable connector to 8 to 10 lbf-inch
(9.2 to 11.5kgf-cm). Repeat this for the screw at the bottom right of the connector. Alternate between
the two screws until both are tight.
Repeat Steps
Step 4
If you are installing a cable near cables that are already installed, you might need to gently hold back the
surrounding cables. Make sure you install cables in pairs, Tx and Rx, each time.
Figure 20-15
March 2005
Tx
JACKSCREW SHOULD BE
INSTALLED FIRST AND
REMOVED LAST
Tx
JACKSCREW SHOULD BE
INSTALLED FIRST AND
REMOVED LAST
1 through 3 for each cable you want to install, moving from the bottom row to the top row.
shows a UBIC-V with cables installed in all connectors.
DLP-A386 Install Electrical Cables on the UBIC-V EIAs
DS1/DS3
Tx
Tx
Cisco ONS 15454 Procedure Guide, R5.0
JACKSCREW SHOULD BE
A
INSTALLED FIRST AND
REMOVED LAST
(SLOT 3) (SLOT 2) (SLOT 1)
P
TX
LD
P
RX
HD(SLOT 2) HD(SLOT 1)
J7 J5 J4 J1
REAR COVER
BRACKET
LOCATION
Rx
HD(SLOT 2) HD(SLOT 1)
J15 J13 J12 J9
HD(SLOT 1) HD(SLOT 2)
J2 J3 J6 J8
Rx
HD(SLOT 1) HD(SLOT 2)
J10 J11 J14 J16
(SLOT 6) (SLOT 5) (SLOT 4)
TX
LD
RX
REAR COVER
BRACKET
LOCATION
20-71