Vcat Circuit Route Constraints - Cisco ONS 15454 Series Procedure Manual

Chapter 6 Create Circuits and VT Tunnels
Node-Diverse Path—(Split routing only.) Available when Fully Protected is chosen.
•
Click Next. If you chose Fully Protected or PCA, click OK to continue. If not, continue with the next
Step 13
step.
If you selected Using Required Nodes/Spans in
Step 14
with Step
In the Circuit Route Constraints area
a.
the Route member number drop-down list.
Click a node or span on the circuit map.
b.
Click Include to include the node or span in the circuit, or click Exclude to exclude the node or span
c.
from the circuit. The order in which you choose included nodes and spans is the order in which the
circuit is routed. Click spans twice to change the circuit direction.
Repeat Steps b and c for each node or span you wish to include or exclude.
d.
Review the circuit route. To change the circuit routing order, choose a node in the Required
e.
Nodes/Lines or Excluded Nodes Links lists, then click the Up or Down buttons to change the circuit
routing order. Click Remove to remove a node or span.
Repeat Steps
f.
Figure 6-19
Step 15 If you selected Review Route Before Creation in
continue with
In the Route Review/Edit area, choose the member that you want to route from the Route member
a.
number drop-down list.
Click a node or span on the circuit map.
b.
August 2005
15:
a through e for each member.

VCAT Circuit Route Constraints

Step 16:
NTP-A264 Create an Automatically Routed VCAT Circuit
Step 9, complete the following substeps. If not, continue
(Figure 6-19), choose the member that you want to route from
Step 9, complete the following substeps; otherwise,
Cisco ONS 15454 Procedure Guide, R5.0
6-89